GHRH analogue is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2025-11-12. Numbers and descriptions here follow the published literature rather than marketing material.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Two forms circulate under the CJC-1295 name, and they differ by a single appended group. The version without a drug affinity complex carries four substitutions along the peptide chain, including a D-alanine near the amino terminus and replacements at three other positions. These changes block the enzyme dipeptidyl peptidase IV and remove a methionine residue that is prone to oxidation. The modified fragment is frequently labeled MOD GRF 1-29. Naming conventions are inconsistent across informal sources, which is a common source of confusion.
The second form adds a maleimide-bearing linker to the lysine at the carboxyl end. This group reacts with cysteine-34 on circulating serum albumin, forming a covalent bond that keeps the peptide in the bloodstream for far longer. ConjuChem developed the molecule as a way to extend the action of a peptide without frequent administration. The albumin attachment is the defining structural feature of the drug affinity complex version. Whether continuous exposure produces effects distinct from shorter pulses remains an unresolved research question.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Assessed by visual inspection under ordinary light |
| Primary analytical method | Reversed-phase liquid chromatography | Purity estimated from peak area at 214 nm |
| Confirmatory method | Mass spectrometry | Observed mass compared with calculated value |
| Powder storage temperature | Minus 20 degrees Celsius | Minus 80 for extended archival periods |
| Solution stability | Hours to days at 2 to 8 degrees Celsius | Influenced by pH, buffer, and concentration |
The compound emerged from work at a Canadian biotechnology firm in the early 2000s. Early human studies examined its effect on growth hormone and insulin-like growth factor 1 in healthy volunteers and in people with HIV-associated fat redistribution. Reports described sustained increases in both markers after a single injection. Development did not advance to regulatory approval, and the clinical programme was later discontinued. The molecule is now encountered mainly as a research chemical rather than a marketed medicine.
Two forms circulate in research settings and are frequently confused. One carries the drug affinity complex and is often written as CJC-1295 with DAC; the other lacks that group and is usually called modified GRF(1-29). The two share the same core sequence but differ sharply in how long they persist in blood. Products labelled only as CJC-1295 normally refer to the version carrying the complex. Documentation that omits the distinction leaves the intended molecule ambiguous.
Binding to GHRH receptors on pituitary somatotroph cells triggers cyclic AMP signaling and stimulates growth hormone synthesis and release. Because the peptide acts upstream of the pituitary, effects are mediated through endogenous growth hormone rather than direct receptor activation in peripheral tissues. Increases in insulin-like growth factor 1 are generally described as a downstream consequence. Most published human exposure data come from small early-stage studies, and the clinical significance of the pharmacokinetic profile remains incompletely characterized.
CJC-1295 is a synthetic analogue of growth hormone-releasing hormone, built on the 29-amino-acid GHRH(1-29) fragment. Four substitutions distinguish it from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes reduce enzymatic cleavage and extend the peptide's persistence in circulation. The compound is discussed in two forms, one carrying a drug affinity complex and one without it.
The drug affinity complex is a maleimidopropionic acid group attached to a lysine side chain. It reacts with the free thiol of cysteine-34 on circulating albumin, forming a covalent bond. This conjugation keeps the peptide in the bloodstream and shields it from rapid renal filtration and proteolysis. Reported circulation half-lives for the albumin-bound form fall in the range of roughly six to nine days in early human studies.
These organostannanes are also stable to both air and moisture, and many of these reagents either are commercially available or can be synthesized from literature precedent. However, these tin reagents tend to be highly toxic. X is typically a halide, such as Cl, Br, or I, yet pseudohalides such as triflates and sulfonates and phosphates can also be used. Several reviews have been published.
Initial letters are used where there is no ambiguity: C cysteine, H histidine, I isoleucine, M methionine, S serine, V valine. No other amino acids in this set begin with each of those letters. Where arbitrary assignment is needed, the structurally simpler amino acids are given precedence: A alanine, G glycine, L leucine, P proline, T threonine. For example, alanine is simpler than arginine or asparagine, the other amino acids starting with "a". F PHenylalanine and R aRginine are assigned by being phonetically suggestive, W tryptophan is assigned based on the double ring being visually suggestive to the bulky letter W, K lysine and Y tyrosine are assigned as alphabetically nearest to their initials L and T (note that U was avoided for its similarity with V, while X was reserved for undetermined or atypical amino acids); for tyrosine the mnemonic tYrosine was also proposed, D aspartate was assigned arbitrarily, with the proposed mnemonic asparDic acid; E glutamate was assigned in alphabetical sequence being larger by merely one methylene –CH2– group, N asparagine was assigned arbitrarily, with the proposed mnemonic asparagiNe; Q glutamine was assigned in alphabetical sequence of those still available (note again that O was avoided due to similarity with D), with the proposed mnemonic Qlutamine.
Californium is produced in nuclear reactors and particle accelerators. Californium-250 is made by bombarding berkelium-249 (249Bk) with neutrons, forming berkelium-250 (250Bk) via neutron capture (n,γ) which, in turn, quickly beta decays (β−) to californium-250 (250Cf) in the following reaction:
Sources: en.wikipedia.org
== Development and regulation in the United States == The solid filiform needle used in dry needling is regulated by the FDA as a Class II medical device described in the code titled "Sec. 880.5580 Acupuncture needle is a device intended to pierce the skin in the practice of acupuncture". Per the Food and Drug Act of 1906 and the subsequent amendments to said act, the FDA definition applies to how the needles can be marketed and does not mean that acupuncture is the only medical procedure where these needles can be used. Dry needling using such a needle contrasts with the use of a hollow hypodermic needle to inject substances such as saline solution, botox or corticosteroids to the same point. The founder of Integrative Systemic Dry Needling (ISDN), Yun-Tao Ma, has spearheaded the "dry needling" movement in the United States. Ma states, "Although ISDN originated in traditional Chinese methods, it has developed from the ancient empirical approach to become modern medical art rooted in evidence-based thinking and practice." Ma also states that, "Dry needling technique is a modern Western medical modality that is not related to traditional Chinese acupuncture in any way. Dry needling has its own theoretical concepts, terminology, needling technique, and clinical application."
When cyclopentadiene is used as the diene, the vicinal norbornene diol bicyclo[2.2.1]hept-5-ene-2,3-diol is formed after hydrolysis. The Swern oxidation to the 1,2-ketone bicyclo[2.2.1]hept-5-ene-2,3-dione proceeds (in the variant with trifluoroacetic anhydride instead of oxalyl chloride) with a yield of 73%.
=== Role in parturition === CRH is synthesized by the placenta and seems to determine the duration of pregnancy. Levels rise towards the end of pregnancy just before birth and current theory suggests three roles of CRH in parturition:
Figure 3 shows B versus R∗ for the rough pipe data of Nikuradse, Shockling, and Langelandsvik. In this view, the data at different roughness ratio ε/D fall together when plotted against R∗, demonstrating scaling in the variable R∗. The following features are present:
Sources: en.wikipedia.org
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.
Dry powder is markedly more stable than solution and is usually held frozen and desiccated. Room temperature exposure over days degrades it more slowly than most people assume, but long-term integrity favors freezer storage. Light protection is recommended regardless of temperature.
Methods, columns, gradients, and detection wavelengths are not standardized across laboratories. Some figures describe only the main peak area at one wavelength and ignore water, salts, or counter-ions. Without stated conditions, comparing reported percentages across sources is unreliable.
It is a synthetic peptide analogue of growth hormone-releasing hormone. Four substitutions in its sequence make it more resistant to enzymatic degradation than the natural hormone. In the version carrying a drug affinity complex, the peptide binds albumin and remains in circulation for days.